After using the vortex fan for a long time, it is necessary to carry out ash removal. Do you know how to remove ash? How do you disassemble the top cover during routine maintenance and inspection?

Cut off the large shaft wind guide cover of the machine equipment, connect the screw cap, lift the upper end of the wind guide cover with a crane, remove the dust accumulated inside the wind guide cover, and lift all personnel on the large shaft flange with iron sand. PE and 5 tons of manual bamboo shoots and melons. In order to better ensure the belt bearing capacity of bamboo shoots and melons, Ye Luan adopts fully automatic bamboo shoots and melons and galvanized steel wire rope lifting. The connecting screw and safety of the large shaft flange are fused from the flange to the circle of the blade pivot shaft, and the centrifugal impeller is rapidly promoted. How to disassemble the top cover of the high-pressure fan?

Please remove the outer cover of the high-pressure fan bearing and the bearing seat, and store them properly. Clean the accumulated dust on the centrifugal impeller and investigate the damage condition of the centrifugal impeller. If you have other maintenance, please check whether your shackles are liquid. The bearing head and neck are not worn, with particle size and crevice corrosion traces, and the bearing seat is not worn. The gap in the bearing part of the subsequent dust collector is 0.1~0.16mm, and the gap in the Copernicus bearing is 0.13~0.25mm, and the gap in the shaft foot is 0.1~0.7mm.